Material Safety Data Sheet

Trade Name as Used on Label

Delco Cleaning Systems of Fort Worth Delco’s Clean-Creteä

Distributor

2513 Warfield Street June 12, 2001

Address Date Prepared

Fort Worth, Texas 76106

Website: www.dcs1.com Email: delco@dcs1.com

800-433-2113 Robert M. Hinderliter

Phone Number (for information) Prepared by:

800-255-3924 or 813-248-0585

Emergency Phone No.

SECTION 1 – MATERIAL IDENTIFICATION AND INFORMATION

Components – Chemical Name & Common Names (Hazardous Components 1% or greater; Carcinogens 0.1% or greater)	%	OSHA PEL	ACGIH TLV	OTHER LIMITS RECOMMENDED
Kaolin	49
Quartz, Amorphous <1.0%
Crystalline Silica <0.1%
Smectite	47
Quartz, Amorphous <1.0%
Crystalline Silica <0.1%
Non-Hazardous Ingredients	4
TOTAL	100

SECTION 2 – PHYSICAL / CHEMICAL CHARACTERISTICS

Boiling Bulk

Point N/A Density: 40-50lbs/FT3

Vapor Pressure Melting

(mm Hg and Temperature) N/A Point >2000°F

Vapor Density Evaporation Rate

(Air = 1) N/A (_______________= 1) N/A

Solubility Water

In Water Insoluble Reactive None

PH: 5-9

Appearance

And Odor Cream to light tan granular solid; odorless

SECTION 3 – FIRE AND EXPLOSION HAZARD DATA

Flash Point and Method Used N/A

Auto-Ignition Temperature N/A

Flammability Limits in Air % by Volume N/A

LEL N/A

UEL N/A

Extinguisher

Media Not Combustible – Use appropriate extinguishing media for material supplying fuel

Special Fire

Fighting Procedures Dependent upon material supplying fuel; wear protective clothing and use self contained breathing

Apparatus

Unusual Fire and

Explosion Hazards None

SECTION 4 – REACTIVITY HAZARD DATA

Stability Conditions

X Stable To Amend

Unstable Non Known

Incapability

Materials To Amend None Known

Hazardous

Decomposition Products None Known

HAZARDOUS POLYMERIZATION Conditions to

May Occur Avoid

X May Not Occur None Known

SECTION 5 – HEALTH HAZARD DATA

PRIMARY ROUTES X Inhalation X Ingestion CARINOGEN

OF ENTRY Skin Absorption Not Hazardous LISTED IN NOTE*

Note: This product contains clay. A naturally occurring component of clay is crystalline silica (e.g. quartz and sand are forms of crystalline silica). Repeated overexposure and inhalation of crystalline silica may cause pulmonary silicosis. The International Agency for Research on Cancer (IARC) has classified crystalline silica as a probable human carcinogen (Group 2A).

HEALTH HAZARDS Acute

Nuisance Dust

Chronic

Repeated overexposure by inhalation may cause silicosis

Signs and Symptoms ASA airborne nuisance dust in unventilated environment; sneezing, runny nose, &

Of Exposure watery eyes may occur

Medical Conditions Breathing of dust may aggravate acute or chronic asthma and other chronic

Generally Aggravated pulmonary disease; skin irritation may be aggravated in persons with

by Exposure existing skin lesions

EMERGENCY FIRST AID PROCEDURES

Eye Contact: Hold eyelids open, flush with water and flush with steady, gentle stream for at least 1-2 minutes. Seek medical attention if irritation persists.

Skin Contact: Wash off with soap and water, then continue to flush with water for 1 minute.

Inhalation: Remove to fresh air. If continued respiratory irritation occurs or if breathing becomes difficult, seek medical attention.

Ingestion: Over exposure may cause constipation. Drink copious amount of milk/water.

NOTE TO PHYSICIAN: Treat symptomatically. Consideration should be given to the possibility that overexposure to materials other than this product may have occurred.

SECTION 6 – CONTROL AND PROTECTIVE MEASURES

Respiratory Protection If use conditions generate airborne dust, handle material in an open or well ventilated area. Where

(Specify Type) adequate ventilation is not available, use NIOSH?MSHA approved respirator for dust.

Protective Gloves Eye Protection

Safety Glasses with side shields

VENTILATION X Local Exhaust when necessary Mechanical (general) Special

TO BE USED Other when necessary None

Other Protective

Clothing and Equipment Maintain sink or safety shower, and some form of eyewash station in work area

Hygienic Work Practices

SECTION 7 – PRECAUTIONS FOR SAFE HANDLING AND USE

Steps to be Taken if Material

Is Spilled or Released No emergency results from spillage, however to extent possible spills should be cleaned up using shovels, sweeping or vacuum. Avoid dust generation. Place in appropriate container for disposal and flush with water.

Waste Disposal

Methods Dispose of in accordance with local, state, and federal regulations.

Precautions to be Taken

In Handling and Storage Do not swallow. Do not breathe dust. Avoid getting in eyes, on skin, or on clothing.

Other Precautions

NFPA HMIS

Rating Health 1 Flammability 0 Reactivity 1 Special 0 Rating Health 1 Flammability 0 Reactivity 1 Personal Protection 1

THE INFORMATION HEREIN IS GIVEN IN GOOD FAITH BUT NO WARRANTY, EXPRESS OR IMPLIED IS MADE.

For the latest version of this MSDS Sheet go to http://www.dcs1.com/msds/clean-crete.html

Return to Delco's Crete-Clean